1. Enter programming mode : click ‘*’ + programming-password (1234 is default ) + ‘#’.
2. self-numbered card issuing method: operation method: click ‘2’ ‘1’ + # + read card + 3 digits self-numbering code then wait about 10 seconds

or quick add card: operation method: input 2 “ 0 + # + read card

note: you can read multiple cards at the same time to add cards. if you stop in the card for 10 seconds, the program will automatically exit the management state.

 How to Delete a Card or Medal ?

1. Enter programming mode : click ‘*’ + programming-password (1234 is default ) + ‘#’.
2. swipe card deletion method: operation method: enter 3 0 + # + read card

note: this method can read multiple registered cards at the same time for deletion. if you stop in the card for 10 seconds, the program will automatically exit management status.

How to Restore Factory Defaults?

1. Enter programming mode : click ‘*’ + programming-password (1234 is default ) + ‘#’.
2. restore the factory default to restore the factory default: operation method: enter “7” “0” + “#” note: all parameters are automatically restored to the factory default values after the command is input. (delete all cards, restore all parameters, restore management password: 1234)

How to change Management Password ?

1. Enter programming mode : click ‘*’ + programming-password (1234 is default ) + ‘#’.
2. to change the administrator password:
   enter “6” “0” + “#” + 4-8 digits new administrator password + “#” + repeat 4-8 digits new administrator password + “#”

How to add a password number to open lock or door without RFID Card ?

1. Enter programming mode : click ‘*’ + programming-password (1234 is default ) + ‘#’.
2. click “ 1 ” “ 1 ” + “ # ” + 4-8 digits to open the door + ‘#’ + wait about 10 seconds

now, any time you can write your password + ‘#’ to open the lock or door.

to delete a single password:

1. Enter programming mode : click ‘*’ + programming-password (1234 is default ) + ‘#’.
2. Click “3” “5” + “#” + open password + ” # “